Sealey TA090 Bedienungsanleitung

TA090PAINTTHICKNESSGAUGEOriginal Language VersionTA090 Issue No.1 25/10/12© Jack Sealey Limited

13.1 Measuring, Storage and Data processing in DIRECT and GROUP modeThis gauge offers two operating modes: DIRECT and GROUP mode. The GROUP mode inclu

14.1 CALIBRATION METHODS (General Hints for Calibration).There are four different methods available for calibration:14.1.1 Basic calibration: recommen

Original Language VersionTA090 Issue No.1 25/10/12© Jack Sealey Limited14.6.1 Preparing for calibration:a) Switch the gauge on (keep it away fro

NOTE:14.9.5 Apply the probe to test sample several times.14.9.6 The thickness of the foil should be roughly equivalent to the estimated coating thickn

Original Language VersionTA090 Issue No.1 25/10/12© Jack Sealey Limited 16. MEASUREMENT USING STATISTICSLimits can be entered in DIRECT and a

In the MENU system, you can find the following functions:Delete current data: If you find the last measurement reading is wrong, you can delete it via

1. SAFETY INSTRUCTIONS 3. SOFTWARE INTRODUCTION 4. SOFTWARE INSTALLATION 5. INSTALL USB DRIVERThank you for purchasing a Sealey product. Manu

Original Language VersionTA090 Issue No.1 25/10/12© Jack Sealey Limited 6. MAIN MENU 7. OPERATIONWith the gauge connected to the PC, switch t

8. CURRENT GROUP DATA GRAPHS 9. UM < - > MILS BUTTON 10. GENERAL INFORMATIONClick this button to toggle the units of measurement used on

This gauge conforms to the following industrial standards:GB/T 4956─1985GB/T 4957─1985JB/T 8393─1996JJG 889─95JJG 818─93Features● Measured Coatings:

11.1 Power supplyTo check the battery’s state of charge please press the On/Off key. If the LC display is not lit the battery may be missing or the ba

CONTROLS / FEATURES 1. Probe. 2. Power ON/OFF key. 3. Up/Left key. 4. Left 'bar' key for OK/YES/ MENU/SELECT in menu mode. 5.

12.1 MENU SYSTEMNOTE: Prior to using the gauge we suggest you familiarise yourself with the MENU system referring to the Menu System Map to the right

Press lefthand 'bar' key under display to access MENU SYSTEMLevel One Level Two Level ThreeMENU>Statistic view >>Average view>&g