Sealey SA26 Bedienungsanleitung PDF herunterladen

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions

and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,

WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH

IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE

THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.

1. SAFETY INSTRUCTIONS

 WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to

when using this equipment.

 WARNING!Disconnect from air supply before changing drill bits, servicing, or performing any maintenance.

 Maintain the drill in good condition (use an authorised service agent).

 Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will

invalidate the warranty.

 Use in a suitable work area. Keep area free from unrelated materials and ensure that there is adequate lighting.

 Before each use check condition of drill bit. Sharpen if necessary. If worn or damaged, replace immediately.

 Ensure the speed rating (rpm) of the drill bit is the same as, or greater than, the speed rating of the drill.

 Ensure there are no flammable or combustible materials near the work area.

 Evaluate your working area before using the drill. Ceilings, floors and enclosures may contain hidden

electrical wiring, water pipes or gas pipes.

 WARNING! Always wear approved eye (or face) and hand protection when operating the drill.

 Use face, dust, or respiratory protection in accordance with COSHH regulations.

 Depending on the task, the drilling noise level may exceed 84dB in which case wear safety ear defenders.

 Remove ill fitting clothing. Remove ties, watches, rings, other loose jewellery and contain and/or tie back long hair.

 Wear appropriate protective clothing and keep hands and body clear of working parts.

 Maintain correct balance and footing. DO NOT over reach, ensure the floor is not slippery, wear non-slip

shoes.

 Keep children and unauthorised persons away from the working area.

 Check moving parts alignment on a regular basis.

 Ensure workpiece is secure before operating the drill. DO NOT hold a workpiece by hand.

 Check the workpiece to ensure there are no protruding screws, bolts, nuts etc.

 Avoid unintentional starting.

 Remove chuck key before starting the drill.

 WARNING! Ensure correct air pressure is maintained and not exceeded. Recommended pressure 70-90psi

 Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use and ensure

that all connections are secure.

 Prolonged exposure to vibration from this drill poses a health risk. It is the owner’s responsibility to correctly

assess the potential hazard and issue guidelines for safe periods of use and offer suitable protective equipment.

 DO NOT use the drill for a task it is not designed to perform.

 DO NOT operate drill if any parts are damaged or missing as this may cause failure and/or personal injury.

 WARNING! DO NOT drill any materials containing asbestos.

 DO NOT carry the drill by the hose, or yank the hose from the air supply.

 DO NOT force, or apply heavy pressure to the drill; let the tool do the work.

 DO NOT place air line attachments close to your face and DO NOT point at other people or animals.

 DO NOT operate drill when you are tired, under the influence of alcohol, drugs or intoxicating medication.

 DO NOT use drill where there are flammable liquids, solids or gases such as paint solvents and including

waste wiping or cleaning rags etc.

 DO NOT carry the drill with your hand on the trigger.

 When not in use disconnect from air supply and store in a safe, dry, childproof location.

INSTRUCTIONS FOR:

AIR ANGLE DRILL

10mm REVERSIBLE

MODEL No: SA26.V3

Original Language Version

SA26.V3 Issue: 1 - 09/07/12

1 2 3 4 5

Inhaltsverzeichnis

Seite 1 - 10mm REVERSIBLE

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly mai

Seite 2 - 4. OPERATING INSTRUCTIONS

2. INTRODUCTION & SPECIFICATION3.1. Air Supply WARNING! Ensure the air supply is clean and does not exceed 90psi while operating the drill. T

Seite 3 - 5. MAINTENANCE

 WARNING!Disconnect drill from air supply before changing drill bit, servicing or performing maintenance.Replace or repair damaged parts. Use

Seite 4 - 01284 703534

NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prio

Seite 5 - OF CONFORMITY

EC DECLARATIONOF CONFORMITYWe the sole importers into the UK, hereby declare that the equipment described belowDescription and Function: ....

Verwandte Modelle: S01047

Kommentare zu diesen Handbüchern

Keine Kommentare

Więcej produktów i instrukcji dla odtwarzacze CD Roland

Modele	Rodzaj dokumentu
MICRO BR BOSS DIGITAL RECORDER MICRO BR	Instrukcja Właściciela Roland MICRO BR BOSS DIGITAL RECORDER MICRO BR Owner`s manual, 16 strony
MICRO BR BOSS DIGITAL RECORDER MICRO BR	Instrukcja Właściciela Roland MICRO BR BOSS DIGITAL RECORDER MICRO BR Owner`s manual, 140 strony
CD-2e	Instrukcja Użytkownika Mode d`emploi - Roland Central Europe, 140 strony
MICRO BR BOSS DIGITAL RECORDER MICRO BR	Instrukcja Właściciela Roland MICRO BR BOSS DIGITAL RECORDER MICRO BR Owner`s manual, 7 strony
CD-2e	Instrukcja Użytkownika CD-2u/SD-2u Brochure, 16 strony
UA-4FX	Instrukcja Użytkownika À lire avant toute chose, 16 strony
Fantom-X8	Instrukcja Użytkownika Fantom-X Brochure, 4 strony
Fantom-X8	Instrukcja Użytkownika Fantom-X Workshop Series - American Musical Supply, 21 strony
Fantom-X8	Instrukcja Właściciela Roland Fantom-X8 Owner`s manual, 33 strony
X-7	Instrukcja Właściciela Roland X-7 Owner`s manual, 84 strony
Fantom-X8	Dokumentacja Roland Fantom-X8 Specifications, 60 strony
MICRO BR BOSS DIGITAL RECORDER MICRO BR	Instrukcja Użytkownika BOSS MICRO BR TurboStart, 2 strony
CD-5	Instrukcja Użytkownika JV-1k Supl.Notes, 4 strony
Fantom-X8	Instrukcja Właściciela Roland Fantom-X8 Owner`s manual, 16 strony
CD-2i	Instrukcja Użytkownika Quick Start, 2 strony
CD-2	Instrukcja Użytkownika CD-2_AD1, 1 strony
CD-2e	Instrukcja Właściciela Roland CD-2e Owner`s manual, 132 strony
CDR-88RW-4	Instrukcja Właściciela Roland CDR-88RW-4 Owner`s manual, 12 strony
CD-2	Instrukcja Użytkownika Customers using the Roland R-1 The CD-2 is compatible with the R-1, 1 strony

Sealey SA26 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Werkzeug Sealey SA26 herunter. Sealey SA26 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: S01047

Kommentare zu diesen Handbüchern

Roland VR-3EX podręczniki

Więcej produktów i instrukcji dla odtwarzacze CD Roland

Sealey SA26 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Werkzeug Sealey SA26 herunter. Sealey SA26 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Verwandte Modelle: S01047

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Werkzeug Sealey SA26

Roland VR-3EX podręczniki

Więcej produktów i instrukcji dla odtwarzacze CD Roland